How to Build a Trailer to Pull Behind an ATV

104 24

    Construct the Trailer

    • 1). Cut two of the eight foot boards into four foot sections, and then lay them on the ground parallel to each other. The two closest to each another will form the base of the trailer.

    • 2). Cut the two six-foot boards into three foot sections, and then use screws to build two rectangles from these pieces.

    • 3). Use the jig saw to cut a piece from the plywood that is three feet wide by four feet long. Screw this piece to the base of the body of the trailer. Then cut the two side boards, each of which will measure one foot wide by four feet long. Cut the front and back panels next, measuring one foot wide by three feet long.

    • 4). Cut four one-foot sections from the remaining 2-by-4 board and screw these to the inside corners of the trailer's base. With all four in place, screw the top frame of the trailer to the standing pieces to form a box, and then screw into place the side boards as well as the front and back boards.

    • 5). Install the tires and wheels to the axle, and then install the axle on the bottom side of the trailer, securing it with carriage bolts. Next, install the tongue of the trailer running from the axle shaft out the front of the trailer. Drill holes where this will be placed, and secure it with carriage bolts in at least three places. Secure the trailer to the ATV hitch with a clevis pin.

Subscribe to our newsletter
Sign up here to get the latest news, updates and special offers delivered directly to your inbox.
You can unsubscribe at any time

Leave A Reply

Your email address will not be published.