How to Wire Tractor Safety Lights

104 44
    • 1). Strip 3/8 inches of insulation off the black and red insulated wire. Connect the red wire to the red wire at the light with a butt connector. Place one wire in each end and compress it with pliers.

    • 2). Connect the black insulated wire to the black wire at the light with a butt connector. Run this wire to a grounding location on the tractor. The ideal spot is under a bolt fastened to the metal frame or body. Loosen the bolt, slide the end of the black wire underneath and tighten it.

    • 3). Run the red wire to the safety light's switch mounted in the cab. Loosen the two terminals on the back of the switch with a screwdriver. Connect the red wire to one of the terminals and tighten it.

    • 4). Strip a 3/8-inch piece of insulation off the end of a new section of red wire. Connect this wire to the other terminal on the back of the switch and tighten it.

    • 5). Run the red wire to the tractor's battery. Cut the wire and strip a 3/8-inch section of insulation off the end.

    • 6). Connect the red wire to the fuse holder's wire with a butt connector. Loosen the positive red terminal on the battery with a wrench. Slide the red wire under the terminal and tighten it.

    • 7). Wrap all of the connections in electrical tape. Secure the loose wires with cable ties and insert the recommended fuse into the slot.

Subscribe to our newsletter
Sign up here to get the latest news, updates and special offers delivered directly to your inbox.
You can unsubscribe at any time

Leave A Reply

Your email address will not be published.