Bleeding Hot Water Systems
- 1). Allow the heating system to run for an hour or so in order to circulate the water.
- 2). Switch off the heating system.
- 3). Locate the bleed valve on the main system tank. This is usually near the bottom. It may look like a standard hose outlet with threading on the edge.
- 4). Cover the bleed opening with the piece of old cloth. This will be used to catch any excess water coming out of the bleed valve. The water will be hot, so you may want to protect your hands with a pair of gloves and cover your eyes with safety glasses. If your boiler is located in a spot that has flooring you would like to protect, place the bowl or newspapers beneath the valve to soak up any water you miss with the rags.
- 5). Open the bleed valve slowly. You should hear a hissing sound as air is pushed out of the system. Take caution as this air could be very hot.
- 6). When water starts to come out the valve, turn the handle to close it.
- 7). On some systems, you will need to add more water after a bleeding procedure. In general, most boilers need slightly more than one bar of pressure when they are not operating, but some may require more. The usual procedure to re-pressurize the systm is to open the valve on the water supply line until you see the gauge on the boiler go over the required minimum pressure.
- 8). Restart the system. Check around the boiler for leaks.