The first step for you to get your vehicle back on the road and working for you is to obtain a neighborhood vendor of motor vehicle supplies. You'll have to be sure you're acquiring the correct alternator for the vehicle since they all perform differently, and they also all fit certain engines and engine bays. Top brand names to be on the lookout for consist of: Bosch, Delco Remy, Prestolite, Mitsubishi, Denso, Nikko/Komatsu, and Valeo. These brand parts contain a great reputation for being reliable and durable. It is exactly what you will want within your vehicle should you want them to keep working for the longest possible time, and reduce down-time.
When you've got the right alternator and are prepared to begin be certain you're not dressed in loose fitting clothing or jewelry which could catch and get ensnared. You're able to remove the power source at this time to begin removing your existing alternator. You need to do this by disconnecting the battery and turning the battery switch to OFF. Then loosen the mounting and tension bolts on the older alternator to remove it. Once it is actually out you can use it as a comparison with the new one. Do the mounting holes match when set against one another? If not you need to look into getting an adaptor or bracket from a local machinist.
Now affix the mounting foot to the engine mount, using the bracket if needed. You may have to add shimming to make sure of a mount that's secure. If you're mounting a dual footed alternator, do not tense up the bolts so much that the 2 mounting ears are compressed. You will see a design feature within the rear bushing that will allow you to slide and tighten the mount.
Inspect the alternator pulley and be sure it's aligned with the engine pulley. This will be your chance for making final shimming adjustments. In the event the water pump is a component of your configuration make time to ensure all three run together well.
Attach the output ground cable, field wire, stator wire, as well as any other wiring that is a part of your assembly. Now connect your alternator wire to the regulatory wiring harness. Consult your manual for the dimension of the alternators positive and ground cables. If you're doing so, this is the time to install a fresh regulator as well as its wiring. You're almost done, the only thing that is left is to do your final checks and your new high amp alternator should be prepared to go.