You'll need to be careful enough to handle a wet tile saw or utility knife.
and patient enough to smooth mortar evenly, yet with grooves.
You'll need several hours, depending on the size of the floor, and if the floor is a bathroom and you have children, a second bathroom that they can use might come in handy, as a couple of hours are required for the mortar to dry.
You'll need the tile, of course.
Your choice of design is entirely your own, but consider how the design will fit in with the rest of the room.
Consider, also, the room's function.
Kitchen floors are always exposed to food and water drips.
Dark ceramic tile flooring would tend to make seeing these drips more difficult when you're mopping the floors.
Light, solid colors are most appropriate for kitchen floors, while darker tile with simple patterns go best in bathrooms.
Shop around at local hardware and home improvement stores or on the net.
If you don't find what you want at your local stores, you're sure to find it on the net.
You can get ceramic tiles from any country on the net.
You're sure to find the design you have in mind there.
Once you have your tile, you can pre-cut tiles that will be placed at the edges of the floor if the tile is too large.
This means you should do some measuring first.
You can also cut the tile while you're laying it, but then you have to be sure you haven't laid down the mortar until you've made the necessary cuts.
Mortar that is only partially dried might not bond with the tile when you set it.
You can use a wet ceramic saw or a utility knife to do the cutting.
Which you use depends on the thickness of your ceramic tile flooring.
To set your ceramic tile flooring, you'll also need mortar and grout.
These are easily purchased at any hardware or home improvement store.
You'll also need a wet tile saw to cut tile, when required, and a trowel to spread the mortar or adhesive in which you set the tile.
You can also use spacers which separate the tiles from each other in an even manner.
If the floor you're covering with ceramic tile flooring is other than concrete, you'll either have to lay concrete first or lay concrete backing boards.
The floor in which you'll install your ceramic tile flooring must be as even as possible.
If it's not, you'll have to even it out first.
Repair all holes and cracks in the floor and clean it thoroughly prior to beginning work.
Once the floor is prepared and dried, you can start laying your ceramic tile flooring.
It is best to lay the tile in pre-separated sections.
Divide the floor into four sections.
You can use grout as a line separator.
Then, for each section, use a notched trowel to spread the mortar.
Hold the trowel at a 45 degree angle so that it creates notches in the spread.
This enables better holding when you set in the tile.
Do not spread too much mortar at once.
If the mortar dries before you can set the tile, you'll have the additional problem of removing it.
When you set the tile, only a light pressure is required.
Depending on the thickness of your tile, you'll have to press it into the mortar a short distance.
Make sure that each tile is even with the next.
Mortar will come up over the sides of the tile, but this can easily be wiped away.
Avoid resting hands or arms on the tile you've set.
It's going to take a couple of hours before the mortar is completely dry.
Grout the ceramic tile flooring, and wipe off any grout that gets on the tile.
Before you get started, view some free videos on the net to see how it's done.
Laying your own ceramic tile flooring can be a very satisfying experience, especially when you realize it's a job well done!